Summary

This will be a lathe with parts of a cordless screwdriver.

Instructions

To use this you have to open your cordless screwdriver(I have opened 2 from different supplier and the measures were the same). Planned are two of this pieces. One on each side. One will be powered the other not.
Between the parts will be a driven table, where your tools will be on.
For bigger parts you will need an adapter because the drill chuck will be too small.

V2 of this Part Info:
I made the cutting part smaller. The holes for the screws above are now M4 not M3. The part is 5mm thinner. Press the screwdriver part into hole is easier you donÂ´t need that much power now.

Homemade Lathe