Summary

This is a fairly generic faucet handle for my basement sink.
It's not for a hot and cold handle. It is a one connection
left for hot, right for cold, pull for off, push for on.

It is connected by a screw into a metal cylinder witha hex nut at one end.

A cover with H and C markings is supplied as well.

Feedback is appreciated.

Print Settings

Rafts:

Doesn't Matter

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10% knob.  At least 30% cap.</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><pre><code>This piece was built   * Using a Flash Forge Creator Dual.  * In ABS at 230C  * Build plate at 110C  * Full support is required, as the inner piece needs support under it.  * Infill of 10% seemed adequate  * Layer height was .30  * one shell was used.  * feed rate was 50/75  * It took about 2.5 hours to print  * I don't recall how much fillament was used, though I am sure it was in excess of 14 meters.</code></pre></div>

Bathroom Sink Faucet Knob