Batman Tape Dispenser

This is a dispenser that I made for my Kapton/polymide tape roll. The tape roll is 1/2" wide with a 3" core. The geometry of the design ended up looking similar to Batman without intentions. The tolerances were designed to press fit the Wheel into the core of the tape. The shafts can be glued or acetone welded. The razor can heat-set into the plastic.

1. KaptonTapeHolder_Shaft.stl (x2)
2. KaptonTapeHolder_Wheel.stl (x1)
3. KaptonTapeHolder_Base.stl (x1)
4. 3" x 1/2" Roll of Tape
5. Jagged Razor from Tape Dispenser