Heavily Modified (Modular) X ends w/ endstop holder.

Updates are at bottom of text

NOTE
When installing these ends pinch the M8 nuts with your fingers and try to get them as tight as possible using the threaded rod run it threw the nuts and attach to your couplings. I will post a better install instruction later, as they are a bit tricky to install. The pulley mount goes on last as well as the motor mount bracket etc.

Original Post
See I have this problem, I have to alter and modify anything I can so here are the X-ends from villekl only modified a slight bit.

There is now an enstop holder that mounts to the top of the x motor end, as well as a pass through on the x motor mount for those of us with long smooth rods, also there are nut traps for m3 nuts on the bottom of the XendBaseV2.stl

I have not installed these as of yet, but plan to install them sometime this weekend. I will update the post and let you know how they work.

Update #2
Installed and updated the design once again, the ID for the rods have been made 9mm to give a little leeway for some printers. My printer does not do bridges very well. If they are loose a wrap or two of blue tape works well. Bearing wells have a bearing lip to hold the bottom of the bearing in place, as well as a spot for a zip tie in the middle of the bearing tower. Extended "wings" have been added to the ends as well to provide even clamping around the bars, as well as some other smaller modifications. After installing I notice almost no z wobble if any at all.

Update #1
I have installed the X_motor mount and have noticed a few issues, and have made changes to the X_motor mount top, bottom, and mount itself. The pass through holes for the rods were not big enough to properly hold the M8 rods. Bolt insets have been added for people who use 20mm m4 bolts like I do. Support has been added to the bearing wells as well as the bearing wells them selfs have been gutted a little to add just a bit of wiggle room. I almost needed a vice to put my bearings in.

Once I install this set I will update and let everyone know how they work.

Printed Parts
Both extended and regular versions will work. Regular motor mount and pulley mount will not mount properly to the extended versions.

Regular ends "No wing"
1 x XendStopHolder V2.stl <-- not required
2 x Top_X_Motor_V3.stl
2 x Bottom_X_Motor_V5.stl
1 x X_Motor_Mount_V5.stl
1 x X_End_Idler_V3.stl

Extended Ends
2 x Bottom_X_Motor_V6.stl
2 x Top_X_Motor_V4.stl
1 x X_Motor_Mount_V6.stl
1 x X_End_Idler_V4.stl