Kinect V2 Mount For Sony Bravia KDL-32BX420

I needed a mount for my TV, for my Xbox One Kinect. I have filament and felt I might as well make my own. My tv has a front bezel 44mm in height (top of the front edge to the bottom edge of bezel. It has an 85mm depth, with a curve height of 69.85mm (from the top of the tv set to the end of the curvature, but not following it) and I limited how far down the straight back portion it goes to around 77mm, to the printing limits I am constrained to. It has a slot to fit a half inch 1/4-20 hex bolt and a small recess to fit the rubber underpad of the kinect in. I used the kinect itself to 3D scan the curvature of the tv. I had originally wanted to make the back long enough to add two bolt holes for the wall mount pattern in the back, but my printer can't go above 100mm.