Not Mega Blok 1x1 w/slight dome

This is the same as my Not Mega Blok 1x1
http://www.thingiverse.com/thing:1195909
but I added a little more material on the tippy top, essentially a tiny dome.
Settings essentially the same as before on a Printrbot Simple Metal
.3mm layer thickness
1.6mm shell
Brim with 4 lines

I did test a wide range of PLA, including lots of inexpensive translucent PLAs from justPLA.com. They seem to need a little high temp clean out, but otherwise, so far so good. Time will tell. Translucent PLA parts came out looking nice and can be used as phone beacons! Enjoy. -Joe