Fruit Drain Plate

Juice from melons in a container naturally collects at the bottom.
The fruit drain plate improves melon quality by keeping it above the juice.
Its diameter is 23cm to fit a vintage Tupperware cake holder.
A monolithic plate would not fit the MakerBot build space.
So, the plate is split to 2 identical halves.
Fruit Plate2 squeezes two halves side-by-side to print them concurrently.
Legs near the split are 2mm longer to flex the center up for draining.
The plate is thin to print quickly and flex gracefully.

For a different printer, with a smaller, 6x6" build space,
I split the plate in quarters, and replaced the legs with a solid border.
The four quarters snap together with a round binding peg.