Summary

Icosahedron connector for a dome. Create any size dome, just by adding longer rods.

Instructions

Print 11 connectors and connect them together with 25, 1 inch dowels. Each dowel must be the same diamter and length. If you want to use a smaller or larger dowel, the part can be scaled up or down to accept your new size dowels.

The print settings used for my prints where 3 shells, 10% infill and a 0.2 layer height.

This is a work in progress because I plan to add an LED connector for the top of the dome that will either accept batteries or solar panels. Also, there is a plan to skin the dome so it can be used as a tent.

11 Piece Icosahedron Dome Kit