Border for 3D Printed Settlers of Catan

This border is designed to fit the set created by trevorclarke. It snaps together from two separate pieces for the edge and corners. For a complete set, you will need to print six of each kind. I was able to fit two of each on my FlashForge Dreamer to be able to print an entire set in three prints.

It is pictured with the set from trevorclarke.

As you can see from the pictures, it isn't a perfect solution, but it is a good one. When I get a chance, I will redo the pieces to make for a little leeway around the edge. They are currently very tight, which makes it difficult to put all of the tiles in. Perhaps scaling either the border slightly up or the tiles slightly down might work.

I am including the blend files in case someone wants to modify it slightly.