Summary

Quadcoptor Leg V1 for 250 Frame

Print Settings

Printer:

CTC 3D Printer

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>75%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>ABS<br>Heatbead 130c<br>Nozzle 230c</p><p>takes about 2 hours as the build has two legs at the same time</p></div>

Post-Printing

Legs fitting nice and snug

legs fresh off the print not sure if it worth acetone them

sits nice and lower down than the original legs original legs needed held on but tie wraps or would fall off and loose them no problem now

Quadcoptor Leg V1 250 size