Summary

A two-part button with magnets that snaps over accessory cables to secure their loose ends to a metal object.

Instructions

Printed in ABS with 0.25mm layer height and 0.4mm nozzle diameter.

Uses 1/4" x 1/10" rare-earth disk magnets. If a press-fit is too loose, then put a drop of super glue on the back of the magnet so that it wicks into the gaps without causing a mess on the front face.

Once the magnets are installed, just put a cable into the slot of the larger piece, and then snap the smaller piece onto the larger piece to secure the button to the cable.

If you are careful with the polarity of the magnets (making sure each button has a north pole on one side and a south pole on the other) then you can stack the buttons on top of one another.

Magnetic Cable Holder Button