Summary

Super Dungeon Explorer board game uses lots of these little cardboard coin-shaped tokens, so I built a holder for 18 sets of them.

Also included the Sketchup file and component so you can tweak or remix.

Print Settings

Printer:

Zortrax M200

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.19mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>"Full"</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>The uprights broke consistently while printing on my old un-lamented Solidoodle SD4, so I set infill to "Full", which is the maximum, (though not 100%), to make it stronger.  This resulted in an 11-hour print, so I'd probably back off on the infill to speed thing up if I were to print it again.</p><p>Also it's a little more snug on the Zortrax printer, but still works fine.  I might open up the Hole offset (or print the whole thing a little bigger).  You probably want to print the component and check for fit before firing off the big piece.</p></div>

Super Dungeon Explorer Token Dispenser