Underslung Power Supply Mount for Vision Prusa Mendel Printers

This power supply holder was designed for the Vision iteration of Prusa Mendel printer which uses thick acrylic sidewalls. I wanted a better way to mount the 115mm wide power supply unit that was also relatively visually appealing.

It requires a 200mm build plate and needs clamping bolts (I used 25mm M3).

The images above are of my first print - this has since been tweaked and will look slightly different.

Depending on your setup you may need to use the risers to lift your printer as by default the PSU is ~10mm lower than the print walls.

There are some changes I would like to make but have not yet for time reasons. Included are the Sketchup files. I would stretch the rear arms out to be as wide as the front arms for ease of installation.