Summary

This is a cover that goes over the male end of a power cord, adapter, etc to protect the terminals. It will fit polarized and non-polarized plugs and supports both 15 and 20 amp plug configurations on 120 or 240 volts (with ground).

NEMA:
5-15
5-20
6-15
6-20

Print Settings

Printer:

Da Vinci 1.0

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>400 Microns</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print face up</p></div>

Post-Printing

Test Fitting

            <div><p>The tolerances in the spades will initially make the cover fit on very tight. However it'll loosen up with removing and putting it on. You can also file the spade areas a small bit if necessary.</p></div>

Female 120/240 Volt Plug Cover