Downward Blower Duct for Replicator 2

I have found when printing PLA, on some parts where even cooling is critical, the stock blower duct on the Replicator 2 is uneven. Favouring right to left movement, rather than left to right on the X axis. So I set about designing a new blower duct that directs air directly downwards for more even cooling. This design has gone through several iterations, but the latest one appears to do the trick.

As proof of concept I printed an enhanced version of the Make Magazine Torture Test using my redesigned blower duct and I think the results speak for themselves. There was a bit of excess stringing which obscures the results, but no dangling from the overhangs except the arch which had a modest amount.

UPDATE (Aug, 31, 2013) I added a small gusset to the design to stiffen it when printed in Nylon.