EdTracker Case for V2 PCB and MPU 9250

So i picked up an EDTracker kit and the V2 PCB before realising that the switch would not fit on the board with the MPU 9250 which came with the kit. Rather than loose the switch i decided to wire it to the board and build a case to hold the switch.
Its not very elegant but it did the job.

The PCB and switch mounting are a tight fit as i did not want them moving around, in my case one of the retaining arms for the switch cracked when i was pushing in the switch, this may vary with each printer, mine didn't make the switch post that great (a few globs on it). I little spot of super glue fixed the cracked arm.

After i had put everything together i shrunk the latches on the lid a little in case it would print a little too tight. It stays in place but may be a little loose. ( A little electrical tape can fix that.)