Summary

I loved making this, it was pretty exciting to see it print out. I was too chicken to print it without supports but my printer seems intent on knocking them down anyway. Printed out pretty well in the end.

https://youtu.be/vkL7jBJqcd8

Print Settings

Printer:

FlashForge Finder

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>

Post-Printing

A little deburring was needed to get rid of the supports and sort out the hole in the top. Not much though, it only took 10 minutes.

Sorting out the circuit took about half an hour and it was up and running.

Filament

Flashforge Blue PLA @ 205c.

and some generic brand (Excelvan possibly) transparent filament again @ 205C.

Light Up Tardis