Summary

Cute Drop-Shaped Pendant
Please if you print it, share pictures of your creations :)

Thanks!!

Print Settings

Printer:

ZORTRAX M200

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.19 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>FULL</p></div></p>

Post-Printing

Acetone cold vapor

            <div><p>After the print I used acetone cold vapor for a shiny finish</p><p>You need:</p><ul><li>Acetone</li><li>A tumbler glass</li><li>Wire</li><li>A cap (a sheet of paper will be fine)</li><li>Patience (It will take approximately 1 hour)</li></ul></div>

Small Drop-Shaped Pendant