Fabrikator Mini PLA Fan Add-on shroud

PLA + Extruder 30mm Cooling fan shroud for those who want a dedicated PLA cooling controlled by software, this will require editing to the Firmware to be able to use the Fan pins for software use and also running a separate fan to the extruder which could be tedious work.

I have two versions one is thinner and slightly shorter and another is slightly thicker and about 2mm longer, I added a genuine E3D V6 extruder so mine was 1-2mm longer than the stock extruder. The shroud will also need to be clipped 1 extruder fin lower than where the original shroud normally clips to give clearance.

!! YOU MUST LIMIT Z HEIGHT TO 58MM !! this is so the extruder cooling fan does not run into the acrylic when printing above 58mm!!! I'm working on trying to offset the extruder fan so this doesn't happen.