Printrbot LC V2 Conversion : Metal Gear Extruder + Bowden + E3D Hotend

This is a conversion kit for the following parts :

• E3D Hotend : http://e3d-online.com/ourshop/prod_2781400-E3Dv5-All-metal-HotEnd-175mm-Direct-Extrusion.html
• Metal Gear System Extruder : http://www.reprapsource.com/en/shop/list/201
• Bowden cable

It should work with the bowden provided with the E3D hotend, just check the pneufit thread diameter.

Be careful with your printer calibration, especially for the carriage : any misalignment will "block" the carriage on the rods.

The extruder placement I chose was not the wiser : it is a bit painful to change the filament.

Finally, many thanks to ajd4096 for his quick fit carriage scad file, and to Joachim Glauche for the extruder design (found here : https://github.com/Joaz/machine_parts/tree/master/mgs_prusa)