Summary

Holden Commodore VE SS emblem keytag. The resolution isn't the best as I'm still learning the software, but it looks OK when printed. Approx 82mm long x 13mm wide, 3.5mm thick (3 1/4" x 1/2" x 1/8")

Print Settings

Printer:

Duinotech TL4090

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>Layer Height 0.25mm, Path Width 0.35mm, 0 extra shells</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>These are the settings I used but it should work with most settings. The file resolution is a little rough so there's not much point printing it at maximum resolution.</p></div>

How I Designed This

File made from a .JPG image using 3D Builder and 123D Design

Holden SS Emblem Keytag (Medium-Res)