Summary

This Pegasus Rocket model is my first attempt at a large, multi-part model. The tallest part is less than 150 mm tall, so this should work on many types of printers.

8-23-2017:
Removed work-in-progress notice.

Print Settings

Printer Brand:

LulzBot

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Mini</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Pick a low resolution; this model doesn't have a lot of small details and will take a while to print.  Structure is only needed on the "Pegasus End" piece.</p><p>The "Pegasus Wing" piece has difficulty with delamination on the wingtips, so make sure you have good adhesion if you are going to print full-size.  I haven't experienced print failure from the wingtips pulling off the surface, but the wing surface is adversely affected.</p></div>

Post-Printing

Depending on how your material shrinks, you may have to sand or file away excess material to make the parts fit together. Once you can slide them together, glue the pieces in place (superglue works well for ABS and PLA).

Pegasus Rocket Model