Summary

While watching #Zeldathon Recovery, I made a ring with an opposing Triforce design.

If you enjoy this design, please make a donation to Zeldathon! Please mention where you came from in the comments. If you're not sure how much to give, I recommend $3.00 as a good starting point. (Or $3.14 if you're nerdy.)

Photos are of a size 14 ring, 9mm high. I've also included some other sizes in case you don't want to use the Customizer.

Print Settings

Printer:

Rapide Lite 200 v1

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1mm (recommended)</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Sliced with Cura, printed in silver PLA. My best results came from printing with an 0.1mm resolution, although it can also be printed at 0.2 for fitting samples.</p></div>

Post-Printing

After printing, you'll want to clean up the print a little bit with a knife, just enough to make sure there aren't whiskers or bumps on the inside of the ring.

How I Designed This

This design originated and ended in OpenSCAD.

Fun fact: the Triforce is made by subtracting a rotated cylinder of diameter D from a cylinder with diameter 2D... both cylinders are rendered with a "number of fragments" of 3, which reduces them to triangular prisms.

Custom Section

Customization

            <div><p>Make sure to experiment with the Advanced Options if you want to change the ring's size or fine-tune other parameters.</p></div>                <p class="detail-title"><strong>Troubleshooting</strong></p>            <div><p>If you are having trouble getting the ring to stick to the raft, you may need to experiment with "Thinnest Layer" in Advanced Options.</p></div>                <p class="detail-title"><strong>Licensing</strong></p>            <div><p>You are granted a Creative Commons Attribution-Non-Commercial-ShareAlike License.</p><p>If you upload your design to Thingiverse, please use the "Remix" feature.</p><p>If you upload your design elsewhere, please link to this page or pikaworx.com.</p><p>I reserve the right to negotiate special licensing.</p></div>

Zeldathon Recovery Triforce Bas Relief Ring