Summary

A figure of the Pokémon Klinklang. It doesn't rotate, unfortunately. It's just a statue.

This figure is pretty small by default, so you might want to scale it up. Just remember to use the same scale factor for all the pieces.

Sorry to all those who printed the large gear before I updated it 6/29, because you'll have to print it with the new STL since I forgot to run a boolean difference operation. Or you could drill a hole. But I don't advise that.

Print Settings

Rafts:

Yes

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>Depends</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print the rim with very high infill, at least 75%. The base should be at least 60%, the large gear should be at least 25%, and Gear 2 (the small one with the pegs sticking out) should be at least 30%. Everything else can be standard. Also, print everything with a few more shells just so you can sand or file a little if you have to later.</p></div>

Post-Printing

If pegs don't fit, break out the sandpaper and file and go to town until it does fit.
Use glue to hold everything together.

Klinklang Figure