Fully Customisable Power supply Endcap... yep another

Well it be another end cap for those power supplys everyone is so fond of.

Didnt like the ones I saw so made my own.

It's fully customisable... well as far as I could think to make it.

It specifically setup for a switch/ kettle plug combo I got with the one i purchased.

UPDATE:-
So after having this installed, I found that it needed nut captions to hold them in place. As such I ended up using rivets. Issue with this is that it didn't hold well enough and pulled loose.

I have made version 2 with 2 slots added to hold nuts.

Only uploaded scad file at this stage, as measurements of slots not fine tuned yet. you will need to set these dimensions to the correct dimensions of the nut being used.