Summary

An enclosure for the arduino-based monome-clone (for instructions on that, see http://flipmu.com/work/arduinome/). Made for the SparkFun Button Pads.

Instructions

I've made it from acrylic using a lasercutter. The bottom has screw holes to hold two standard arduino duemilanoves.

Use the screw holes on the bottom layer of the front to mount the spark fun button pads and pcbs to the front and then mount the whole bottom layer of the front to the top layer with the left-over screw holes.

It ended up being a bit of a tall build - there was a bit of space left between the button pads and the pcbs even when using an out-of-the-box arduino, so you might want to make the sides smaller, especially if you use a custom made pcb and don't need the extra space.

Arduinome Enclosure