Summary

A pokeball used for Cosplaying your own trainer!

Can be attached to belt using your preferred method: velcro, hairtie loop, magnets, whatever your mind can think of.

Print Settings

Printer Brand:

MakerBot

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>MakerBot Replicator Z18</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.1-.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>any</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print ball center in black, button in gray or white, and ball top in whatever colors you want for top &amp; bottom of ball. Alignment tool is completely optional.</p><p>I print with a raft since they print better, but you can safely do so without depending on your build plate. Support should not be necessary.</p></div>

Post-Printing

Assembly

            <div><p>After printing, decide how to attach balls to belt (if applicable) and whether or not to use alignment tool. For my attachment method I used my soldering iron to poke a small hole at the back of ballcenter, then glued a stretchy hairtie halfway through hole.</p><p>If using the alignment tool, snap it onto ball center first using the long insert to center the tool through the button hole and then make sure arms are mostly centered/parallel. Press both ball tops against tool, making sure to center button cutouts, and pull off one half. Use superglue along center &amp; top seam to secure one half. Remove tool and glue in button. For other half, use reverse side of tool to keep spacing consistent and spread glue along top edge of center, Align button cutout with other half and press other ball half together.</p><p>Enjoy your new pokeballs!</p></div>

Belt sized Pokeball