Kabab - Hyperlite HS1177 TPU Mount

[UPDATE 9/15] Adjusted the FPV with plate new version is 4.7 and prints great! BTW the 4.6 version without the middle plate prints great, I will post pictures very soon.

[UPDATE 9/13] Latest versions are 4.5 and 4.6. Both versions have been cleaned up and Antenna angle's have been adjusted and Antenna hole size adjusted. The 4.6 version includes a middle plate. Both versions should print much better now.

Note: I created these designs using Unit = Millimeters. You can open the files in MeshLabs and document check the measurements.

This very similar to the TPU mount that comes with the Hyperlite. I am adding several versions of the mount here. Versions 2 and 2.1 do not have antenna mounts (I am working on versions with antenna mounts. I will have a left and right version so you would need to print one of each.

I recently purchased the Kabab 5" and Hyperlite Frames and the folks that produce this do not share they SLT files on their website, so I designed this one.

It's designed to be used on the Kabab or Hyperlite frames but would work on any build that using a 20mm standoff. If you have the skills it can be modified to work on any frame that uses 30.5x30.5 standoff spacing.

Enjoy