Summary

**Masquerade version is now on Thingiverse as a Remix of this!! http://www.thingiverse.com/thing:1064014

*I modified this mask to house 25 5mm RGB LED lights (from adafruit) in the mask. I also added slits on the sides to add a strap. The battery holder holds 2 9-volt batteries.

For different voltage sources use this great resistor calculator to determine the correct resistors.
http://led.linear1.org/led.wiz

Print Settings

Rafts:

Doesn't Matter

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>5%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p><em>Natural or any other clear material.<br></em>Do not scale for original Replicator*  </p></div>

Post-Printing

            <p class="detail-title"><strong>LED Wiring:</strong></p>            <div><ul><li><p>I used adafruits.com Diffused 5mm Slow Fade Flashing RGB LED. They are great for beginners as they don't require any programming skills. <a rel="nofollow" href="http://www.adafruit.com/products/679">http://www.adafruit.com/products/679</a><br>-Check to see if lights fit in place as PLA has a tendency to warp<br>-Once you are sure the lights fit, glue them in place with a fast drying adhesive that works well with plastics<br>-Solder lights in place with their associated resistors<br>-To connect the mask to the battery pack, I used male/female DC Connector Size: Out-side diameter 5.5mm, In-side diameter 2.1mm. I used adhesive to mount this wire to the left edge of the mask passing right in front of my ear and down my back.<br>-I used a silicone adhesive sealant to seal all the exposed LED leads and wire.<br><em>Disclaimer: I make no claims that this mask is actually safe to wear. I am not liable for any injuries caused by electrical shock. MAKE AT YOUR OWN RISK</em></p><p>*Refer to pictures for the wiring diagram</p></li></ul></div>                <p class="detail-title"><strong>Liner/Strap:  </strong></p>            <div><p>-The stap is made by sewing 3/4" velcro strap made up of 3"of the "hard" side of velcro and the rest is made up of the "soft" side of velcro.<br>-I trimmed a piece of soft cotton from a fabric store. This is held in place with velcro sewn to it so it can be washed.<br>-To stop light leaking into your eyes causing flares in your vision, use a dark opaque material such as electrical tape to black out the eyes. as an added effect of the tape the mask become creepier.</p></div>

LED low poly mask