Summary

A simple design for converting a Logitech C600 webcam for telescope use.

Print Settings

Printer:

Prusa i3 improved

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>50%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Support needed when printing adapter tube, should not be needed for back.</p></div>

Post-Printing

Instructions for tearing down the C600 webcam can be found here:

https://www.ifixit.com/Teardown/Logitech+2-MP+Webcam+C600+Teardown/1504

Remove lens, leave IR filter.

Verify orientation of board when placing it in the adapter tube - corner cutouts are smaller on one side of the board.

Pieces should snap together - tight tolerances.

Logitech C600 webcam CCD telescope adapter