Summary

For mounting PowerPole DC connectors on DIN rails, facing upwards.

You can buy DIN rail mountable DC power supplies on ebay, for example Meanwell brand. It's convenient to mount one of these next to it, if you like using PowerPoles instead of wiring directly.

You can screw a short M3 bolt into the bottom to hold it more tightly in place on the rail.

Print Settings

Printer:

AIO Zeus

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.28mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>The critical thing is how well your slicer and printer can handle short bridges.  Mine does a good job: the plastic doesn't sag too much.  It's probably best to print in the designed orientation because you need tensile strength to hold the clamp onto the DIN rail; however this requires bridging over the areas where the connectors will be installed.  If those cutouts are too narrow, the part might split when you try to shove the connectors in.</p></div>

How I Designed This

See http://www.thingiverse.com/thing:1788780 for more information: this uses the same DIN rail clamp design.

DIN rail mount for PowerPole connectors: upright