Summary

LM8UU y-carriage for Orca 0.2, created with OpenSCAD.

Printed and tested.

Uses:

Instructions

Print
Clean. If printed with pads, remove pads
Insert LM8UU, if printed with PLA it may be necessary to warm the holder to avoid breakage.
(3a. Optional, but recommended: Put a little bit of glue under each LM8UU before insertion)
Remove old y-carriage
Insert new y-carriage, attach base plate, longer screws may be necessary, 4xM4x35 should fit.

The carriage has the same height as the original y-carriage.

Comments/suggestions are appreciated.