Modular VAWT Verticle axis wind turbine

This is a modular VAWT that can be made on smaller printers. It can be stacked as high as needed to get the torque required for your energy production. This is a work in progress so things will change however at this point in time it fully functional.

the hub should be printed with double thick walls and at least 50 percent infill
the rods should be 100% as should the fins and the bottom bearing, top bearing should be 50%+. all of the project is designed to slot into each other part so its pretty fool proof. you can add glue if necessary. fins may need support depending on your print material.

both top and bottom bearings will need to be "seasoned" run them for a while to break them in and then add a little bit of oil. power extraction can be done via the top bearing. i found the top bearing to be most problematic, had to run it with an electric motor for half a day before it was loose enough to move freely.

video showing operation!
https://www.youtube.com/watch?v=rHLFTU9vK0I