inMoov Wrist Gear Standard Servo Mount

Remix of magicaltrevor's "Wrist Gear for standard servo mount for Inmoov rotating wrist"

I created this due to printing problems with my Replicator2 (Overhangs and internal structure).
I have successfully printed this Part with my R2, but have not yet tested it with my servo or in the full assembly. Stay tuned for updates!

I hope you don't mind magicaltrevor, ant thank's a lot for the original design!!!

And shoutout to the inMoov Project!!!
--

18.11.2013 - UPDATE
Updated the Part to adapt hairygael's original top gear. Thank's for the input!
Part is printed but not assembled.

Made with: Replicator 2
Infill 30% / Shells 3 / Layer Height 0.2mm / No Rafts / No Supports / Build Time 16min / Weight 2.47g

22.11.2013 - UPDATE
Updated the height and the diameter of the bottom (servo) gear to better fit my standard servo. The part should now fit a 5.9mm Servo gear.
However, when you print this part in PLA and put it on a plastic servo, you might get problem with the traction of the servo assembly. Whit a metal servo you should be golden.

Made with: Replicator 2 / PLA
Infill 30% / Shells 3 / Layer Height 0.2mm / No Rafts / No Supports / Build Time 14min / Weight 2.17g