Summary

a simple cube for travel and fidgeting - now pocket sized!

Post-Printing

Assembly is very simple. Just print out 4 cubies, 1 of each core, and a pin. Depending on your printer's quality, you may need to file the cores a little bit. Insert the pin into the tapered core, and put all the cubies on both cores. Apply glue to the end of the peg, and insert it into the other assembly. let dry, and enjoy!

UPDATE:
glue one of the cubies to one of the cores to prevent the cube from getting stuck.

Acnowledgements

This cube was based off if a mix of adrbot's 1x2x2, and my limit cube. It was optimized to be printed small, and does so even on my not- too- accurate replicator 1.

rubiks 1x2x2