Summary

This holds the pieces for the board/card game Splendor - 90 cards, 40 chips and 10 tiles. The lid is included.

Post-Printing

Organizer and lid fit.

            <div><p>I printed mine on a Deezmaker Bukito printer.  From prior designs, I've found that I need to design a lid with about 0.04" to 0.06" extra play to fit over a rectangular thing.  That is the "padding" variable in the OpenSCAD file.  padding=0.02 gives 0.04" of extra space.  At 0.02, I still had to sand the exterior of the base box a bit to get the lid on (and back off).  Your mileage may vary.</p></div>

How I Designed This

Small footprint

            <div><p>My Bukito printer has only a 140x150x140 mm build volume, so I needed an organizer and lid that would each fit in that volume.  All the ones I could find required two 2.5" cards side-by-side, so I could just barely make the base organizer, but not the lid. With this design, even the lid is 4.40 x 3.88".</p><p>I also wanted a design without the need for any supports.</p></div>

Splendor Game Organizer - small footprint