EXPERIMENTAL Rc Ducted Fan V1 (Source included)

This is a very experimental edf, designed for a 370 size motor. It should fit this motor fine, but I don't have a 3d printer yet to test it.

I have no idea if either pla or abs will hold up to the temperatures of the motor after continuous use. As I said, this is very experimental. I am not responsible for any damage or injuries caused by printing this design.

60mm OD
54mm ID
3mm shaft hole
propeller for 2.3mm shaft
2 parts, pins should fit them together nicely
The body should print without support, but the top piece may need it. Also, the propeller will need support.

As of now, all pieces are cross compatible. AKA you can use a front V1 with a back V2 or any other combination you want.

Any feedback is greatly appreciated