Summary

UPDATED

Now you have my lasted build.

You can now open the holder whit your finger :)

Dont forget to add ANTI-SLIP pad

This is a simple charging station for the new Charge 2.

Concept was basic but on desk look like sexy :D
No spécial config for print.
The square hole are bigger than the charger so you can add soft material :)
Slicer = Slic3r
Infill = 10 or 15
Layer Height = 0.2mm
"Vertical shells" Perimeter = 3

Print Settings

Printer:

Quebot V1

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Add supp if you want i never try whitout supp but i guess you can do it !!!!!</p></div>

Post-Printing

FITBIT Charge 2 Charging Station UPDATED

Concept was basic but on desk look like sexy :DNo spécial config for print.The square hole are bigger than the charger so you can add soft material :)Slicer = Slic3rInfill = 10 or 15Layer Height = 0.2mm"Vertical shells" Perimeter = 3

Concept was basic but on desk look like sexy :D
No spécial config for print.
The square hole are bigger than the charger so you can add soft material :)
Slicer = Slic3r
Infill = 10 or 15
Layer Height = 0.2mm
"Vertical shells" Perimeter = 3