MacBook Pro/Air Holder

I was re-created in OpenSCAD 3D models.

It is possible to change the thickness of the MacBook you have because it can be adjusted in the slot spacing.

It takes much longer when you run it "(F6) Compile and Render" because it uses, "minkowski" command, however. (6-24 hours)

• the display is the highest speed that is set to "0" parameter of "edge_r" is when you want to preview. ("fn $ = 16/32" also change the speed up)

[macbook_holder_v4_215.stl] => slot spacing 21.5mm
[macbook_holder_v4_265.stl] => slot spacing 26.5mm