Printrbot Plus Base Aluminium Plate (Extended X/Y)

1/4in thick Aluminium plate to replace wood base of Printrbot plus. Acrylic legs. Extends X-Axis by 1in and X by 1/2in. Easier access to electronics.

Note:
To stabilize X axis rods, ~0.1in shim required between x-axis rods and Z axis bearings (See picture). This clamps the rods really well and I get better stability than previously non-extended version. An alternative would be to buy new rods, but who wants to do that?

Also, please realize that the electronic mounting holes are for ramps. You will also need a 90deg USB-B type connector or use ~1in standoffs to clear the y axis bearing block.