Summary

This is a open project called "Drone it yourself". It allows you to 3d print parts to make a drone, then use everyday objects as the frame.

Instructions

First, Print these parts

4 x motor_mount – the part that holds the motor
4 x clamp.stl – the main body of the clamp
4 x clamp_bar.stl – the small block that forms the other end of the clamp
4 x bolt_handle.stl – a
1 x box_top.stl
1 x box_bottom.stl

Next, get these parts
16 x Plain washer, M3 (4 for each motor) – 189-620
16 x Hex socket cap screw, M3x20mm (4 for each motor) – 293-325
4 or 8 x Wing nut, M4 (1 for each clamp, or 2 if you use the extenders) – 521-850
8 / 16 x Plain washer, M4 (2 for each clamp, or 4 if you use the extenders) – 189-636
4 / 8 x Hex socket cap screw, M4x30mm (1 for each clamp, or 2 if you use the extenders) – 290-118
4 x Hex bolt, M4x60mm (1 for each clamp) – 279-571
4 x Mex nut, M6 (1 for each clamp) – 189-591

Now, Assemble the Clamps That will hold your Propellors, Motors and Electronics

(Refere to the Last picture in the slideshow for the assembly)

Now, get your electronics

4 x Motor
1 x Propeller kit (2 times left and 2 times right rotating)
1 x Propeller accessory pack
4 x ESC (electronic speed controller)
1 x Radio receiver (with a minimum of four channels)
1 x Flight Controller

More coming soon

Drone It Yourself Printable Parts V1.0