Summary

It's called "Tink Pank" because it's a Pink Tank!!!!

Drogerdy 1.0 remix with "single (merged) parts" body and built in Raspberry Pi Camera front.

I'm a noob on 3D modeling...

Added electronics plate .stl files (bottom and top) for 9v battery, hg7881 motor controller, sunfounder quadruped robot board with arduino nano and nrf24

Print Settings

Printer:

Tronxy i3 Clone

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1 - 0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20% - 50%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printed most of it with 0.2 (low) resolution at 20%. This is good for the body parts but the cogs should go with 50% infill and higher resolution (0.1 - 0.15) and the track pieces sucked at 0.2/20% so I reprinted at 0.1/50% and this last setting worked fine.</p><p>If you have the time and patience to do so, print the track pieces and cogs at the highest resolution possible and at least 50% infill.</p><p>Some parts needed supports (main body for sure does)</p></div>