VESA NTC C.H.I.P. Mount

Customizable mount for an NTC C.H.I.P single board computer that I can use with my monitor attached to a stand; that is why the CHIP is not mounted in the center of the VESA mount. I originally drew a dual mount for the C.H.I.P., but I wanted to make a customizable version. I am starting with a single CHIP mount, as I expect that to be the most common.

If you want to change the orientation of the board, just swap chip width and length, and then you can turn on or off the top / bottom or left / right sides as you wish.

Planned additions:

• DONE: Adding the screw hole for the CHIP to better secure the board. Currently it is relying on tight tolerances to hold the board in by friction.
• DONE: Add in the dual CHIP support even though I no longer plan on using it this way. (Mainly for OpenSCAD learning.)
• Done: Have a separate wall thickness from plate thickness.