Summary

I have moddified the "nerftracks" to work with my RC car TORMENT.

Instructions

5 shells 10% fill and 30mm layers

print 2 track bodys A and 2 track bodys B
print 2 drive wheels mod. these are the big wheels
print 8 idler wheels 4 for each track and 84 track pads

to assemble you will need to buy some bolts to hold it together.

6 1 1/2" long bolts with lock nuts they cost me $0.09 each.

print all the parts and Body A will lock into Body B after you put in all the wheels. just be sure to have the Drive wheels facing the right direction and have the idle wheels in before you glue the tabs and press the two bodys together.
next just put the bolts for the idle wheels in and dont get them too tight they are axels and the wheels need to spin.

finaly you need to assemble the track itself.
thats easy. get a soldering iron hot and start by melting a peice of fillament so the end is flatened out like a nail. cut it to the length of the bolts you bought. then stick the fillament into the 4 holes of the track pads and melt the other end of the fillament.
Repeat untill you have enough to wrap around the whole thing then do the last one when it is wrapped around the track body.

RC Tracks