Summary

This is similar to the one sold online, only plastic and printed from your bot. Allows easy modification of your AR Drone 2.0 forward-facing camera, to allow viewing angles from 90 straight up, to 90 straight down. Overenginerred design includes ~22 degree snap-to angles and ribbon cable guide.

Instructions

Printed at a sigle shell is best, due to detail of design. A good, precise printer is required. You may want to slow down your bot to make sure it prints well. Adds only 0.2g to your drone.

Find a bolt and nut that will fit in the hole. For best results make sure the bolt fills the entire hole by adding a shim, drinking straw, or shrink-tube to the bolt. The included printed bold is intended for testing purposes only, and not for use in flight.

You can tuck the camera's ribbon cable down through the hinge for protection, though you may need to cut a bit more off of the front of your drone to do this.

Watch the guide on youtube for information about doing this camera mod. Do your homework! Dont screw up your drone because of me.

Use care when cutting feet off finished print.

AR Drone 2.0 Camera Swivel Mount Mod