Summary

This thing is a keychain 3D sculpture that I made as a souvenir from my 3 months trip in Bulgaria. It's been inspired by the concrete blocks you will see along Varna's dock and on other bulgarian seeside.

Това е един ключодържател, че правих като спомен от моето пътуване в България.
Всичко хубаво!

http://www.spacymen.com

Print Settings

Rafts:

Yes

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.25mm layer thickness</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Due to the very small areas in contact with the print bed I guess printing on a raft is mandatory.<br>But you can print the upside-down version instead which doesn't need a raft but will need more support (50°). The photos of the printed keychain are of the upside-down version.<br>There are 2 small holes at the top. These can be used to glue a small 1.75mm diameter piece of filament as a hook (see photos - if you print it with ABS, use aceton to glue it).</p><p>The keychain is 4cm high.</p></div>

Post-Printing

The 2 small holes at the top are for gluing a small piece of 1.75mm filament as a hook for the keychain. When printing with ABS, use aceton to glue it in place.

How I Designed This

All the modeling was done in SketchUp.

Souvenir of Varna (Bulgaria)