Summary

Just a basic replacement Quixo Block.

Print with either the X or O side down and no support will be needed and no problem with drooping on the lettering.

Lettering is inverse extruded (intruded?) deep enough to allow for a few coats of low build primer and then your whatever color coating and faux wood finish you choose.

It does not need it, but I used a 30% infill to get close to approximate weight of original piece.

Print Settings

Printer:

FLUX Delta

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.15</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Infill could be lower if you wanted, around 30% is a nice match for weight approximation.</p></div>

Post-Printing

Low base primer, faux wood finish, and hand painted lacquer.