Summary

10 cm high, detachable leg for X525 quadcopter.
I used the original hardware to install.
The base stays on the quad when leg detached.

This is a part of my X525 project:

APM 2.6 case w. damper
Middle accessory plate
Battery tray with low voltage alarm case
Mobius cam, board camera tilt camera mount

Print Settings

Printer:

Geeetech Prusa i3 clone

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.15 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100 %</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I printed with 20% fill amount for support (in Cura), in order to have smoother surface inside the leg.<br>Leg must be rotated to lay during printing!</p></div>

X525 quadcopter - 10 cm detachable leg