DIY Head Tracker Box

I made this box for the ardiuno nano board and the sensor for the DIY Head Tracker on RcGroups. The box has no mechanical fasteners just a tight fit. If it doesn't hold well use a little hot glue on the inside corners and then push it together. I may update the design, when I get some time, and add four small screws in the corners.

I updated the box and added screws to the corners. The screws are 3X12mm countersunk self tapping. There pretty common and should be at all the hobby shops. I also mad the usb hole a little bigger, it was a bit to tight.

I made a couple more changes on this box and labeled it V4. I changed to some small 2mm wood screws for a cleaner look and i made the inside of the box a little deeper to accommodate the pins on the ardiuno board. You will still need to remove the 6 pins on the end.