Mr. Hairy Muttonchop

Beardo #1: Mr. Muttonchop
Loosely inspired by Hairy Lion and the Chia Pets (cool band name!), I modeled this figure in the preview version of Adobe Fuse, then added the hair using Microsoft 3D Builder. It uses modified sections of The Furry Vase (http://www.thingiverse.com/thing:1800503) to simulate hair without requiring the "sacrificial" exterior cylinder used on the Hairy Lion (http://www.thingiverse.com/thing:2007221).

Instructions: Print without support. (The hair is not supposed to print "perfectly.") The two pictures show the printed results with and without styling the "hair" with a heat gun. I used 0% infill, 2 shells, 0.2 layer height, no raft, no support. Printed with Seacans Gold PLA at 205C.

Note: I've increased the amount of "beard" since the sample model was printed. Leave a comment if you'd like to see more "Beardo" figures. Have fun!

Tools: Adobe Fuse, Meshmixer, 3D Builder, NetFabb